Figure 10 Front Loader, Parcel Only (No Master Door) - Long Description These units are designed to provide separate parcel delivery capability for wall-mounted, centralized mail receptacles installed without integral parcel compartments. When the carrier activates a master loading door latch mechanism mounted on the unit frame, the outer edge of the master loading door shall be automatically opened a minimum of 1 inch outside the door frame, enabling the carrier to easily grasp the door. USPS ENGINEERING, DELIVERY AND RETAIL SYSTEMS Figure 8 Front Loader, Double Column & Master Door (No Parcel Compartment) - Long Description Learn More. The doors shall be held open at an angle of 90 degrees (+5,-0). The approved source shall submit its quality documentation to the Postal Service for review along with the preliminary design review. I think your best bet would be to contact the postmaster at your local Post Office. The unit shall be tested in a finished condition, including all protective coating, paint, and mounting hardware and shall be thoroughly washed when submitted to remove all oil, grease, and other nonpermanent coatings. The hole pattern for the lock is shown in figure 14. The lock and door shall remain closed and locked after each test. This activity shall be carried out at appropriate stages of manufacture to ensure that only acceptable products are delivered. Finished or coated surfaces shall be smooth and uniform, and free from soft areas, stain, chips, crazing, and cracks. may be used in the fabrication of the receptacle, providing it produces a satisfactory and safe joint and is performed in accordance with applicable best commercial practices. 7.1 Disapproval Written notification, including reasons for disapproval, will be sent to the manufacturer within 30 days of completion of the final review of all submitted units. A mail deposit slot 10.75 inches wide by .75 inches high shall be provided with a weather shield and a security shield to protect the deposited mail from the rain and snow and to prevent removal of the mail by fishing and pilfering techniques through the deposit slot. 5.3.6 Corrective Action The approved source shall maintain a documented complaint process. By clicking Accept all cookies, you agree Stack Exchange can store cookies on your device and disclose information in accordance with our Cookie Policy. The USPS, may, at its discretion, revoke the approval status of any product that does not meet the requirements of this standard. Each lock shall be provided with three keys as specified in section 3.11.1. Customer Service; . Type II, Front Loader A family of mail receptacles in a double column configuration with a double master door design, a minimum of 3 and a maximum of 16 customer compartments, 1 mail collection compartment with separate outgoing mail slot and Arrow lock door, and 1 or 2 parcel compartments. These keys are durable and reliable, ensuring that your mailbox remains secure and accessible. The master loading door for any single door receptacle design and the right master loading door for any double master door design shall, as a minimum, have provisions and accommodations for a three-point (top, middle, bottom) latching mechanism, exclusive of the hinges, in conjunction with either a standard or modified Arrow lock to secure the door. Test Evaluation & Quality One is a master key - also called an arrow key -. The REAL Reo. All keys shall have any burrs removed and shall move freely in and out of the lock. >. 3.9.1 Customer Compartment Identification Customer compartment doors shall be identified using either numbers or letters, optionally, in sequence from top to bottom. Perhaps this is a question I should just ask the USPS directly, but I wanted to first try to collect some third-party experience with the process. 3.5.4 Collection Mail Compartment Blanking Plate (Rear Loader Designs) Rear loader receptacles shall have a blanking plate, sized to cover a minimum 3 inches high by 12 inches wide compartment, directly beneath the collection mail slot. Any front doors of customer compartments in alignment with the cables may be opened or removed for the test. Is this plug ok to install an AC condensor? English version of Russian proverb "The hedgehogs got pricked, cried, but continued to eat the cactus", Generating points along line with specifying the origin of point generation in QGIS. 4.11.4 Master Loading Door (Front-Loading Designs only) Seams around the perimeter of the master loading door(s) shall not allow access to the interior of the receptacle when tested using pry tools listed in 4.11 for a period not to exceed 3 minutes. (b)Large Parcel Locker 18 inches high by 12 inches wide x 15 inches deep. It is not the intent of this standard to attempt to standardize these systems, but to present the basic functional concepts that when conscientiously implemented will provide assurance that the approved sources product meets the requirements and fully matches the approved design. Usps Arrow Key Template. The receptacle design shall preclude access from one compartment to another and it shall provide the required level of security for all receptacle contents and resistance to vandalism. Connect and share knowledge within a single location that is structured and easy to search. Usps Arrow Key Template - Fill Out and Sign Printable PDF Template Product Details Genuine ILCO brand key blanks Made in USA Nickel Plated Brass Sold Individually Manufacturer Equivalents Ilco 1646R Jet D4301 JMA NTC-14, NTC14 Original D4301 Confirming the key you're choosing is correct VIEW THIS KEY IN REAL SIZE Actual size line drawings and groove pattern profiles are available in our manufactures directory. An arrow lock is a lock with standard dimensions used by the United States Postal Service for mail carriers to access collection boxes, outdoor parcel lockers, cluster box units, and apartment mailbox panels. A 3-pound hammer shall be used for a time period not to exceed 1 minute in tandem with these other tools during the tests of the seams and gaps around the perimeter of this item. Where can I get a USPS arrow key? - Quora 2.2 Government Documents The following documents of the latest issue are incorporated by reference as part of this standard. In addition, a legible and permanently marked decal with USPS-STD-4C, the manufacturers name, address, date of manufacture (month and year), unit serial number, and model number or nomenclature must be affixed to the receptacle in a location that is readily visible to carriers. 3.18 FabricationandAssembly All components and parts shall be fabricated and assembled to be permanently square and rigid to preclude binding, warping, or misalignment, which may reduce or prevent proper equipment operation or maintenance or may result in a premature failure of any part or component. The receptacle will have failed the sand abrasion test if less than 15 liters of sand penetrates its coating or if less than 75 liters of sand penetrates its plating. Further, the Postal Service did not restrict the number of replacement arrow keys that could be ordered. How does one even go about making an install request? (http://www.astm.org), UL 771 Night Depositories (Rain Test Only) Seams and gaps around the perimeter of the Arrow lock compartment door and the structural integrity of the door itself shall not allow access to the receptacle under test conditions. To learn more, see our tips on writing great answers. USPS-L-1172 or equivalent shall be identified and perform in the following manner to allow for efficient control, security, and operation. It would be difficult to acceptably explain why you want blanks to the master lock to the mailbox array. The manufacturer bears all responsibility for their unit(s) meeting these requirements and the USPS reserves the right to retest any and all units submitted including those which are available to the general public. Type I, Front Loader A family of mail receptacles in a single column configuration with a single master door design, a minimum of 3 and a maximum of 8 customer compartments, 1 mail collection compartment with separate outgoing mail slot and Arrow lock door, and 1 parcel compartment. 4.2.3 Parcel Compartment Parcel compartments must meet minimum capacity requirements tested by insertion and removal of a standard test gauge which measures 14-15/16 inches high by 11-15/16 inches wide by 14-15/16 inches deep. The master loading door(s) shall be easy to open and close. Additional DAL ($0.070) or DML ($0.090) fees apply. Copies of the preceding document can be obtained from Underwriters Laboratories Inc., 333 Pfingsten Road, Northbrook, IL 60062-2096. One postal worker had me fill out a form and pay $50 for someone to come out. Type III, Front Loader A family of mail receptacles in a double column configuration with a single master door design, a minimum of 3 and a maximum of 16 customer compartments, 1 mail collection compartment with separate outgoing mail slot and Arrow lock door, and 1 or 2 parcel compartments. If you show up in person they equally seem confused. 3.5.1 Customer Compartment Doors Once opened, a customer door shall remain in the opened position until closed and locked. Clearance between the door and door opening shall be evenly spaced and consistent in size. In addition, no offered outgoing mail compartment height shall preclude any of the critical installation requirements, or any other requirement, from being met, and no compartment size shall be offered that is larger than any fully tested size. Figure 6 Front Loader, Single Column (No Parcel Compartment) - Long Description Any parcel compartment provided as an integral part of a receptacle design shall have a 910 lock that is keyed differently than any customer compartment lock in the receptacle. 00 @ -| Dissimilar metals shall be protected against galvanic corrosion. So my question becomes, before I consider ordering one of these: How do you go about getting the actual lock installed? "Three minutes, from start to finish," said Hawley, the president of her . Optional outgoing mail compartment heights shall be allowable. Parcel compartment doors shall be numbered (typically, 1P, 2P, etc). How do you make a key log? I ended up just walking over and making the request in person, which worked out well enough, but it did require going down there. All bolster plate cables will be tied together at a minimum distance of 3 feet from the front surface of the unit with a single cable fitted with a shackle, hook, etc. Figure 2 Front Loader, Double Column & Master Door - Long Description The 910 lock cover shall be secured with standard hardware while the Arrow lock compartment cover shall be secured with tamper resistant screws. 3.10.1 Customer Compartment Locks Each customer compartment door shall use a PSIN O910 lock, as specified in USPS-L-1172, or equivalent. Individual customer locks shall be located in the compartment doors on the left side. Making statements based on opinion; back them up with references or personal experience. No access to the backside of the unit or to any adjacent compartments shall be gained as a result of this test. All correspondence and inquiries shall be directed to the address listed in 1.3. All parcel compartment doors shall be locked for shipment. These forces shall be held for a time not to exceed one minute and then released. Rescission Manufacturers production units shall be constructed in accordance with the USPS-certified drawings and the provisions of this specification and be of the same materials, construction, coating, workmanship, finish, etc., as the approved units. These units are designed to provide separate parcel delivery capability for wall-mounted centralized mail receptacles installed without integral parcel compartments. 6.1.2 Independent Lab Testing Upon receiving written notification from the USPS that their design(s) satisfies requirements of the preliminary review, manufacturers shall at their own expense submit at least one representative sample of the highest total-compartment version of each Type apartment receptacle for which the vendor seeks USPS approval to an independent laboratory for testing along with a copy of the preliminary review letter from the USPS.
Volleyball Student Section Chants, Present Value And Future Value Formula Calculator, Articles U